
![]()
· Note: Due to lack of funding, this research project at the UW is no longer active. We have left this website up for general information purposes only. If you have questions regarding any aspect of LN2 vehicle technology, please direct your inquiries to the researchers at the University of North Texas.
Beyond 2000 Documentary (20MB)
Researchers at the
The LN2000 is an operating proof-of-concept test vehicle, a converted 1984 Grumman-Olson Kubvan mail delivery van. The engine, a radial five-cylinder 15-hp air motor, drives the front wheels through a five-speed manual Volkswagen transmission. The liquid nitrogen is stored in a thermos-like stainless steel tank, or dewar, that holds 24 gallons and is so well insulated that the nitrogen will stay liquid for weeks. At present the tank is pressurized with gaseous nitrogen to develop system pressure but a cryogenic liquid pump will be used for this purpose in the future. A preheater, called an economizer, uses leftover heat in the engine's exhaust to preheat the liquid nitrogen before it enters the heat exchanger. Two fans at the rear of the van draw air through the heat exchanger to enhance the transfer of ambient heat to the liquid nitrogen. The design of this heat exchanger is such as to prevent frost formation on its outer surfaces.
As with all alternative energy storage media, the energy density (W-hr/kg) of liquid nitrogen is relatively low when compared to gasoline but better than that of readily available battery systems. Studies indicate that liquid nitrogen automobiles will have significant performance and environmental advantages over electric vehicles. A liquid nitrogen car with a 60-gallon tank will have a potential range of up to 200 miles, or more than twice that of a typical electric car. Furthermore, a liquid nitrogen car will be much lighter and refilling its tank will take only 10-15 minutes, rather than the several hours required by most electric car concepts. Motorists will fuel up at filling stations very similar to today's gasoline stations. When liquid nitrogen is manufactured in large quantities, the operating cost per mile of a liquid nitrogen car will not only be less than that of an electric car but will actually be competitive with that of a gasoline car.
The process to manufacture liquid nitrogen in large quantities can be environmentally very friendly, even if fossil fuels are used to generate the electric power required. The exhaust gases produced by burning fossil fuels in a power plant contain not only carbon dioxide and gaseous pollutants, but also all the nitrogen from the air used in the combustion. By feeding these exhaust gases to the nitrogen liquefaction plant, the carbon dioxide and other undesirable products of combustion can be condensed and separated in the process of chilling the nitrogen, and thus no pollutants need be released to the atmosphere by the power plant. The sequestered carbon dioxide and pollutants could be injected into depleted gas and oil wells, deep mine shafts, deep ocean subduction zones, and other repositories from which they will not diffuse back into the atmosphere, or they could be chemically processed into useful or inert substances. Consequently, the implementation of a large fleet of liquid nitrogen vehicles could have much greater environmental benefits than just reducing urban air pollution as desired by current zero-emission vehicle mandates.
* Funding for this project has been provided by the U.S. Department of Energy.